The ASN clinch nut is designed to be installed into pre-pierced
holes. The sheet metal is formed into an undercut section on
the nut collar by the die button and the knurled ring. As a
result the nut has high push out and torque values. The
ASN nut is designed for thicker sheet metal applications
(above 1.5mm). A special design of the nut can be used in
thinner sheet metal applications. The unique features of this
nut are that the space requirement is minimal due to the low
outer diameter and that the surface on the screw side stays
flat, no indents.
Can be used in thick sheet metal applications
from 1.5mm to 10mm thick.
Compatible with Class 8, 9, & 10 hardware depending on application requirements.
Contact Sherex should you require inch size threads.
**May require adjustment, depending on
application performance requirements.